Cleaning the drain pump and
non-return valve
If water has not been pumped away at
the end of a program the drain pump or
the non-return valve may be blocked.
^
Turn off the machine.
^
Remove the filter combination out of
the wash cabinet.
^ Tilt the locking clamp to the side.
^
Pull out the non-return valve and
rinse well under running water.
The drain pump is beneath the
non-return valve (see arrow).
^ Before refitting the non-return valve,
check that the drain pump is not
blocked. Spin the propeller several
times in both directions to check for
obstructions.
^ Carefully refit the non-return valve
and secure it with the locking clamp.
Refit and lock the filter in place.
For safety the load should be
washed again.
Cleaning and Care
50
To Next Page
Loading...
