Miele G 7965 - Electrical Connection and Safety

Installation
*INSTALLATION*
124
Electrical connection
Electrical connection
The dishwasher is supplied with an
electrical connection cable with moul-
ded plug ready for connection to a
switched socket.
The socket must be easily accessible
after the dishwasher has been installed.
If that is not possible, ensure that a
suitable means of disconnection is
provided on the installation side for
each pole.
 Risk of fire from overheating.
Connecting the dishwasher to a
multi-socket plug adapter or to an
extension lead can overload the
cable.
Do not use an extension lead or
multi-socket plug adapter.
The electrical system must comply with
local and national safety regulations
(BS7671 in the UK). We recommend
the use of a suitable RCD .
If the connection cable is damaged, it
must only be replaced with a specific
connection cable of the same type
(available from the Miele Customer Ser-
vice Department). For safety reasons,
such replacement may only be carried
out by a qualified technician or the
Miele Customer Service Department.
The data plate indicates the nominal
power consumption and the appropri-
ate fuse rating. Compare the specifica-
tions on the data plate with those of the
electricity supply and make sure that
they match.
If in any doubt, consult a qualified elec-
trician.
Do not connect the dishwasher to a
stand-alone inverter such as those used
with an autonomous energy source, e.g.
solar power. When the washing ma-
chine is switched on, power surges
could result in a safety switch-off. This
could damage the electronic module.