Using for the first time
28
Activating AutoDos
The display changes to the settings
screen for AutoDos (see “Detergents -
Automatic dispensing/AutoDos”).
Even if you do not wish to use
AutoDos, you must remove the
transport locking device from the
PowerDisk compartment before
running the first programme (see
“Detergents - Activating AutoDos”).
You can activate AutoDos.
If you do not wish to use AutoDos, you
can manually dispense the detergent
via the detergent compartment (see
“Detergents - Manual detergent
dispensing”).
Select the setting you want and
confirm with OK.
This setting applies to all programmes
and can be changed in a programme's
Extras menu.
Finally, prompts will appear in the
display.
After confirming these prompts with
OK, the messages Add salt and run the
“QuickPowerWash” programme with the
“Express” option without a load and
Refill rinse aid may appear.
Add salt and rinse aid if necessary
(see “Using for the first time -
Dishwasher salt” and “Rinse aid”).
Select OK to confirm the messages.
When a programme is selected, it will
be shown briefly in the display.
Next, the estimated energy and water
consumption may be shown for the
selected programme for several
seconds.
Finally, the display will show the
estimated programme duration for the
programme selected and then switch to
the Programmes menu.
To Next Page
Loading...
