Miele G 894 User Manual

Technical Information
110
G 600/G 800
Program button Function Options Display
Normal 130 Fault codes - F00, F01, etc.
Sani Wash Operating hours - e.g., 001
Normal 150 Operating hours - e.g., 127
Light Wash Flow meter 195 to 205 195 to 205
Pots & Pans Increase temperature
150°F 50
160°F 51
Economy Water softener
With
1
60
Without 61
China/Crystal Increase water level
Standard
1
70
Increased 71
Table 6-42: G 891 Service Mode 2 Functions
1
Factory setting
6.8.8.3.1 Accessing Fault Codes
1. Access Service Mode 2.
2. Press the Normal 130° program button.
3. The fault code will be shown in the display, e.g., F01, F02, etc.
4. Use the fault chart (Table 6-43) to determine which fault has been stored in the
dishwasher.
5. Turn the dishwasher off.
Fault code Fault
F00 No error
F01 NTC or NTC connections open-circuited
F02 NTC or NTC connections short-circuited
F03 Electronic failure, selector switch position not found
F04
Heating failure - heating circuit opened or defective
electrical component in heating circuit
1
F05 Water drainage failure, heater level switch
F06 Too few pulses at flow meter / start of water intake
F07 Too few pulses at flow meter / end of water intake
F08 Water intake failure, heater level switch
F09
Heater level switch not switching on at the end of
thermal stops
3 dashes (---) in display
Indicates a F1, F2, F4, or F9 fault is stored in the
memory
Table 6-43: G 891 Fault Code Chart
1
All wash programs can be run, but the heating element will not function during the cycle.
6.8.8.3.2 Deleting Stored Fault Codes
Access Programming Mode and press Start/Stop twice.
6.8.8.3.3 Operating Hours
1. Access Service Mode 2.
2. Press the appropriate program button indicated in Table 6-44 to display operating hours.
Program button Display
Sani Wash First 3 digits of total operating hours
Normal 150 Last 3 digits of total operating hours
Table 6-44: G 891 Operating Hours

Miele G 894 Specifications

General

Brand	Miele
Model	G 894
Category	Dishwasher
Language	English