Miele G 894 User Manual

Technical Information
113
G 600/G 800
6.8.9.2.1 Test Program
The test program is a program that allows the technician to check all of the major functions of
the dishwasher.
1. Access Service Mode 1.
2. Using the arrow buttons, select the Rinse & Hold program and press the Start/Stop
button. The test program will start and advance automatically.
3. Pressing the Start/Stop button repeatedly will allow the technician to advance through
the program. If the Start/Stop button is not pressed, the program will run automatically.
6.8.9.3 Service Mode 2
Service Mode 2 is used to determine which upper electronic is in the appliance, to
change programmed functions and to access fault codes. Programmed functions
include increasing the water temperature, turning on or off the water softener, adding
an interim rinse, and setting the dishwasher width (24”). Service Mode 2 is divided
into 3 stages.
Stage Stage function Illuminated light
Stage 1 Fault codes Rinse
Stage 2 Program index Drying
Stage 3 Function programming End
Table 6-48: G 892, G 832 Service Mode 2 Stages
6.8.9.3.1 Stage 1
1. To access Stage 1 of Service Mode 2, close the door and turn the dishwasher on. The
Start/Stop light must be blinking. If the Start/Stop light is not blinking, press and hold
the Start/Stop button for at least 3 seconds to exit the cycle. The Start/Stop light should
now be blinking.
2. Press and hold the Start/Stop button while turning the dishwasher on. Release the
Start/Stop button and immediately press it 2 more times. Flashing Intake/Drain and Salt
lights and a lit Rinse light indicate successful accessing of Stage 1 of Service Mode 2.
3. Use the fault code chart (Table 6-49) to determine the stored fault code. Example: A lit
Normal Plus light and a lit Rinse light = NTC or NTC connections short-circuited.
4. To delete stored fault codes, access the Programming Mode and press Start/Stop
twice.
Fault code Program light and
status
Rinse light
status
Fault
F00 Pots & Pans Lit Lit No error
F01 Sani Wash Lit Lit NTC or NTC connections open-
circuited
F02 Normal Plus Lit Lit NTC or NTC connections short-
circuited
F03 Normal Lit Lit Electronic failure, selector switch
position not found
F04 Economy Lit Lit Heating failure - heating circuit
opened or defective electrical
component in heating circuit
F05 Rinse & Hold Lit Lit Water drainage failure, heater
level switch
F06 Pots & Pans Lit Flashing Too few pulses at flow meter /
start of water intake
F07 Sani Wash Lit Flashing Too few pulses at flow meter /
end of water intake

Miele G 894 Specifications

General

Brand	Miele
Model	G 894
Category	Dishwasher
Language	English