Technical Information
82
G 600/G 800
6.8 Programming and Service Modes
Novotronic Models
6.8.1 G 841, G 841 Plus, G 842
Programming Flow Chart
Enter Programming Mode
To access:
Water hardness settings
Heated drying (G 841, G 842 only)
Extended water intake (G 841, G 842 only)
Enter Service Mode 1
To access:
Manual step mode
Component test program
Enter Service Mode 2
To access:
Fault codes
Program index
Increased water temperature selection
Water softener (with/without)
Interim rinses
Extended water intake (G 841 Plus only)
Dishwasher width setting
EGS (G 841 Plus only)
Table 6-1: G 841, G 841 Plus, G 842 Programming Flow Chart
6.8.1.1 Programming Mode
1. To access the programming mode, close the door and turn the program
selector switch to Stop. Turn the dishwasher off.
2. Press and hold the Start button while turning the dishwasher on. Release the
Start button within 2 seconds. A blinking Salt light indicates successful
accessing of the programming mode.
3. Turn the program selector switch to the position indicated in Table 6-2 to modify
the corresponding function.
4. Use the Start button to toggle the functions on or off.
5. After selecting options, turn the program selector switch to Stop and turn the
dishwasher off.
To Next Page
Loading...
Need help?
General
