Problem solving guide
80
Problem Possible cause and remedy
White residue is visible
on
cutlery and crock‐
ery, clouding occurs on
glassware; film can be
wiped off.
Not enough rinse aid was used.
Incr
ease the dosage (see "Before using for the first
time - Rinse aid").
There is no salt in the salt reservoir.
Fill
the salt reservoir (see "Before using for the first
time - Dishwasher salt").
The salt reservoir cap has not been screwed on cor‐
r
ectly.
Replace it, making
sure that it screws back on
correctly.
An unsuitable combination detergent has been used.
Chang
e your detergent. Use a standard liquid,
tablet or powder detergent, and fill the salt and
rinse aid reservoirs in the dishwasher.
The water softener is programmed to too low a water
har
dness level.
P
rogramme the water softener for harder water
(see "Before using for the first time - Water soften‐
er").
There are rust stains on
cutler
y.
The affected items are not corrosion resistant.
Ther
e is no remedy.
Purchase cutlery which is dishwasher-proof.
A programme was not run after dishwasher salt was
added.
Traces of salt have got into the wash cycle.
Always run the Gentle 45°C p
rogramme with
the Short programme option selected and
without any crockery in the dishwasher after add‐
ing dishwasher salt.
The salt reservoir cap has not been screwed on cor‐
r
ectly.
Replace it, making
sure that it screws back on
correctly.
To Next Page
Loading...
Need help?
General
