Delaying the start time
When the roast probe is being used the
start time can be delayed. The oven will
then switch on and off automatically.
The final core temperature which has
been set determines when the roasting
process finishes.
Proceed as follows:
^
Insert the roast probe into the joint.
Select an oven function and if re
-
quired, adjust the final core tempera
-
ture and/or the pre-set recommended
oven temperature as described on
the previous pages.
^ Press the - button under the timer
display twice.
The f symbol will appear in the timer
display.
^ Use the + button under the timer dis-
play to set the required start time
e. g. 11.20.
The light ring round the programme se
-
lector goes out. A few seconds later the
actual time of day will reappear in the
timer display and the f symbol will
light up.
The temperature values (e.g. 30:80) in
the temperature display will go out
and the e symbol will light up.
Once the start time has been reached,
the light ring around the programme se
-
lector will come on and the oven will
start. In the temperature display the f
symbol goes out and the temperature
values (e.g. 30:80) reappear.
The start time set and the temperature
settings in the display, can be checked
and changed, up until the start time:
to change the start time for roasting
press briefly twice on the - button un-
der the timer display.
To change the core temperature press
briefly twice on the - button under the
temperature display.
Use the relevant + or - buttons to
change the value displayed.
Roasting
37
To Next Page
Loading...
Need help?
General
