The included toekick will fit without
modification if the machine is set to its
maximum height and the toekick is
recessed as far as possible (4"/10 cm).
If the machine height is less than
maximum, or if the toekick is not
recessed 4" (10 cm), the toekick must
be shortened.
The rear of the toekick has two cutting
lines.
^
Screw the toekick onto the installed
brackets, with the cutting lines
towards the top, and pull out evenly
and slowly until it aligns with the
toekick of the adjoining cabinets.
The toekick can not be pushed
back in once it has been extended.
It must be unscrewed, so that the
tension on the spring clips can be
released. The brackets can then
be pushed in, and the toekick
reattached.
Installation
35
To Next Page
Loading...
