^
Carefully open the dishwasher door
until it hits the toekick.
^ Using the front
lower edge of the
door panel as a guide, draw a line
across the toekick.
^ Unscrew and remove the toekick.
^ If one of the cutting lines is close to
the line just drawn, score the front of
the toekick, and snap off the excess,
otherwise, trim the toekick along the
line using a saw.
^
Screw the toekick back onto the
brackets, with the cut edge at the
bottom.
After installation, carefully open the
dishwasher door to check that the
front panel does not hit the toekick. If
it does, remove the toekick and trim
it accordingly.
Installation
36
To Next Page
Loading...
