Extended drying
If desired drying results are not
consistently achieved, the turbothermic
cooling fan can be programmed to run
an extra 14 minutes at the end of each
program.
The "Extended drying" feature can also
be activated to prevent condensation
from collecting on the steam deflector.
Turning extended drying on/off
^
Turn off the dishwasher.
^
Press and hold the & (19) and
"Start/Stop" (21) buttons and at the
same time turn the dishwasher on
using the "On/Off" button.
Release all buttons.
The time display will show P and two
figures. The "Salt" indicator will flash
and the "Energy Saver" and "Sani Wash"
indicators will light.
If this is not the case, the above steps
must be repeated.
^
Press the "Economy" program button.
One of the following will appear in the
time display:
–
90: extended drying is off.
–
91: extended drying is on.
^
Press the "Top Solo" button to change
the selection.
^
Press the "Start/Stop" button.
SP for "Save" will appear in the time
display.
^
Press the "Start/Stop" button again.
The changed extended drying feature
will be stored.
All program indicators will light and the
"Start/Stop" indicator will flash.
^ Turn off the dishwasher.
Operation
38
To Next Page
Loading...
