26
If you are using exhaust filter c or d,
you must also activate the exhaust
filter timestrip® change indicator.
2. If you wish to replace exhaust filter b,
c or d with filter a, it is essential that
you also fit the filter grille *.
* Filter grille - see “Optional ac-
cessories”
When to change the thread lifters
(not possible on EcoTeQ Plus floor-
heads)
The thread lifters on the suction inlet to
the floorhead can be replaced. Check
them from time to time and replace
them if the pile has worn down.
How to replace the thread lifters
Use a suitable screwdriver to remove
the thread lifters from the slots.
Fit new thread lifters.
Cleaning the roller on the AllTeQ
floorhead
Release the bearing (with bayonet fit-
ting) using a coin.
Press the bearing out, and remove.
Remove the roller.
To Next Page
Loading...
