Miele K 5122 Ui - Fitting the Plinth Facing

Building under
40
Fitting the plinth facing
 Place the plinth facing along the run
of units.
 Mark protruding section A on the
ventilation grill console  with a pen-
cil, then take the plinth facing 
away.
 Cut protruding section A off the vent-
ilation grille console.
 If the cut line is not concealed by the
front edge of the plinth facing you will
need to use the cut line further
back.
 Remove the vertical tabs  with a
pair of pliers.
 The supports  on the ventilation
grille will also need to be trimmed to
size by dimension A (= protruding
section on the ventilation grille con-
sole).
 Secure the plinth facing to the kitchen
run .
 Push the ventilation grille onto the
console .