Before using for the first time
The stainless steel trim to the interior
shelves and the door shelves has a
layer of protective foil to prevent
damage during transportation.
^
Clean the inside of the appliance and
the accessories with luke warm water
and a little washing-up liquid, and
then dry with a soft cloth.
^
Carefully remove the protective foil
from the stainless steel trim.
Important:
To ensure the correct functioning of
the appliance, let it stand for
between 1½ and 2 hours after
transporting it to its final location
before connecting it to the mains.
Switching on
^
Using a coin, turn the On/Off dial in a
clockwise direction away from the "0"
position.
Forcing it beyond its range will
damage it. Turn it only as far as it will
go, then turn it back again.
The temperature display for the
refrigerator section will light up and the
interior lighting will come on when door
is opened.
The freezer section temperature
indicator will light up continuously.
The alarm indicator light will also light
up. It will go out when the temperature
in the freezer is cold enough.
The appliance starts cooling.
Allow the appliance to run for a few
hours before placing food in it. This will
ensure that the temperature is
sufficiently low.
Cool pack
Place the cool pack in the top drawer of
the freezer section. The cool pack will
be at its most effective after it has been
in the freezer for approx. 24 hours.
Switching off
^ Using a coin, turn the temperature
selector in an anti-clockwise direction
back to the "0" position.
The cooling system and the interior
lighting are now switched off.
Switching on and off
14
To Next Page
Loading...
Need help?
General
Weight and Dimensions
