Switching on
When using the gas hob an extractor hood or a ventilation
device must be used.
^
The control for the burner required must be pressed in and
turned anti-clockwise to the largest flame symbol to switch
on. The ignitor will make a clicking sound and ignite the
gas.
When a control is operated, a spark is produced on all
cooking zones. This is not a fault.
^
If the burner does not ignite, turn the control to off "ß". Air
the room or wait at least 1 minute before trying again.
^ If the burner does not ignite the second time, turn the
control to "ß", and see "Problem solving guide".
When switching on, re-ignition sometimes occurs (1-2 clicks)
if the flame on the ignition safety device has gone out briefly,
or if the thermal element is not hot enough, e.g. following a
gust of air.
Operation
22
To Next Page
