Safety features
44
Overheating protection
All the induction coils and cooling
elements for the electronics are fitted
with an overheating protection
mechanism. Before the induction coils
and/or cooling elements get too hot, the
overheating protection mechanism cuts
in in one of the following ways:
Induction coils
– Any Booster function in operation will
be switched off.
– The set power level will be reduced.
– The cooking zone turns off
automatically. will flash alternately
with in the timer display.
You can use the cooking zone again as
usual when the fault code has gone out.
Cooling elements
– Any Booster function in operation will
be switched off.
– The set power level will be reduced.
– The cooking zones switch off
automatically.
The affected cooking zones can only be
used again as usual once the cooling
element has cooled down to a safe
level.
The overheating protection may be
activated under the following
circumstances:
– The pan being used is empty.
– Fat or oil being heated on a high
power level.
– Insufficient ventilation to the
underside of the hob.
– A hot cooking zone being switched
on after an interruption to the power
supply.
If, despite removing the cause, the
overheating protection mechanism
triggers again, contact Miele Service.
To Next Page
Loading...
