Installation
*INSTALLATION*
44
Place the washers and nuts back
in position and tighten the nuts .
The cabinet front is now secured.
Now tighten the screws in the angle
trims .
Open the appliance door.
Remove the spacers from the cab-
inet front.
The position of the lower cabinet front
aligns with the position of the upper
cabinet front:
Measure the gap Z between the
mounting frame for the lower appli-
ance door and the lower edge of the
cabinet front above it.
Maintain a gap of 1/8"(3mm) to the
upper cabinet front.
To install the cabinet front to the lower
appliance door, repeat the steps start-
ing from “Preparing to install the cabi-
net front”.
To Next Page
Loading...
