Miele PDR 514 - Page 22

Drying
22
The Start/Stop sensor control will light up.
Programme sequence
- If Delay start has been selected, the Delay start time will start to
count down first.
- The programme starts.
Programme run-
ning time/Time left
estimation
The programme running time depends on the quantity of laundry, the
type of fabric and the residual moisture in the laundry. The displayed
programme running time for drying level programmes can therefore
vary or “jump”. The tumble dryer’s electronic module adapts during
the ongoing drying programme. The displayed programme running
time becomes more and more accurate.
When using the programmes for the first time, the displayed time
sometimes deviates significantly from the real time left. The differ-
ence between the estimated and achieved time becomes smaller if
the corresponding programme is run more often. If different load
sizes are dried in one programme, the time left display can only show
an approximate time.
Laundry items and fabrics can wear out unnecessarily.
Avoid overdrying the laundry.
Energy saving
After a programmed time, the indicators dim. The Start/Stopsensor
control flashes slowly.
 Touch the Start/Stopsensor control to switch the indicators back
on.
Energy saving for the indicators will not affect a running programme.
- The laundry is cooled before the end of the programme in line with
the setting in the programmable function.