Miele PFD 101 - Remote Control

Settings
97
Displaying Connection status
You can call up the current connection
status of your dishwasher.
 Select the Connection status menu
option and confirm with OK.
 Use the sensor controls to
consecutively call up the WiFi signal
strength, the name of your router and
the associated IP address.
 Select OK to confirm the messages.
Set up again
This menu option only appears if you
have already connected your
dishwasher to your WiFi network.
Connect using App
 Select the Connect using App menu
option and confirm with OK.
 Follow the user navigation in the app.
Connect using WPS
 Select the Connect using WPS menu
option and confirm with OK.
 Follow the instructions in the display.
Network configuration
You can use this menu option to reset
all WiFi module settings (if available) to
the factory default settings.
The network configuration should be
reset whenever a dishwasher is being
disposed of or sold, or if a used
dishwasher is being put into operation.
This is the only way to ensure that all
personal data has been removed and
the previous owner will no longer be
able to access the dishwasher.
Remote control
This menu option will only be
displayed if you have connected your
dishwasher to your WiFi network (see
the “Miele@home” section in the
“Settings” chapter)
If you wish to permanently switch off
the Remote control option, you can do so
under this menu option. The sensor
control will then no longer be available
to select until you change this setting
again.
Even if the Remote control option is
switched off, you can use the
Miele@mobile app to call up information
about your appliance. However, you
cannot start any programmes or change
any settings from it.