Miele PLW 8615 - Filling the Dispensing System

System settings
64
Filling the dis-
pensing system
The Fill dispensing systemfunction is used to prime the relevant dis-
pensing system. The function must be carried out after a container for
process chemicals is filled or replaced with a full container.
The function can only be carried out if there are no load carriers in
the wash cabinet.
 Press the Fill dispensing systembutton.
 Press the button for the required dispensing system, e.g., DOS 1.
The individual steps are shown on the display during the process.
Once the process has finished, a message will appear on the display:
Dispensing systemDOS 1 filled.
or
Dispensing systemDOS 1 not filled. Repeat Fill dispensing system.
 Press OK to confirm the message.
If the process of filling a dispensing system is not repeated suc-
cessfully, contact Miele Technical Service.