Problem Possible cause Remedy
The following
appears at the
end of the
programme:
Clean the filter
The dryer is reminding
you that the filter needs
cleaning.
–
Remove and clean the filter.
To delete the fault message:
–
Confirm with OK.
You can adjust the
setting which controls
when or if the message
Clean the filter appears.
–
See "Settings menu J, Cleaning
the filter".
Clean out
airways
The dryer is not working
efficiently or
economically.
Possible cause: The fluff
filter is clogged with fluff
or with detergent
residues.
–
Check all possible causes given
below under "The drying
process goes on too long or
even switches off."
To delete the fault message:
– Confirm with OK.
The vent ducting may be
very long, which does
not constitute a fault.
If very long ducting is used, then
programme times will be longer
and energy consumption higher.
You can adjust the setting which
controls when or if the message
Clean out airways appears.
– See "Settings menu J, Clean out
airways".
Programme finish
time changed
This is not a fault. In the period between selecting
Delay start and the programme
starting, the settings were
changed or there was a power
cut.
Problem solving guide
31
To Next Page
Loading...
Need help?
General
