Transit bars
A message will appear in the display to remind you to remove
the transport bars.
^
Remove them (if this has not already been done by your
fitter). Then press the multi-function selector to confirm that
this has been done.
To repeat the commissioning process
If you are not certain that all of the settings are correct, you
will need to repeat the commissioning process.
Set up successful
i
OK Back A
^ Select Back and confirm your selection.
The commissioning process must then be repeated.
To finish the commissioning process
– 1. Confirm
If you are sure that all of the settings are correct.
Set up successful
i
OK Back A
^
Confirm with OK.
Commissioning the machine
20
To Next Page
Loading...
Need help?
General