With the help of the following notes, minor faults in the performance of this
machine, some of which may result from incorrect operation, can be put right
without contacting the Service Department.
,
Repair work to electrical appliances should only be carried out by a
suitably qualified person in strict accordance with current local and national
safety regulations. Repairs and other work by unqualified persons could be
dangerous. The manufacturer cannot be held liable for unauthorised work.
The programme does not start
Problem Possible cause Remedy
The display remains
dark.
There is no power to the
machine.
Check whether
– the machine is switched on.
– the electricity supply to the
machine is switched on.
– the fuse or circuit breaker
has tripped.
The programme
does not start when
Spin has been
selected.
The machine has not
been prepared for using
for the first time.
Start the Cottons 60°C
programme as described
under "Before using for the first
time".
There is a fault
message in the
display.
A programme cannot be
started while there is a
fault message in the
display.
–
Make a note of what is
shown in the display.
–
Press the multi-function
selector (which will confirm
the message). The fault
message will be deleted.
The display is dark
and the Start button
is flashing slowly.
The display has
switched off
automatically to save
energy (Standby mode).
Press the multi-fuction selector.
The machine comes out of
Standby mode.
Problem solving guide
42
To Next Page
Loading...
Need help?
General
