Connecting the extension tube
^
With the square hole facing the carry
-
ing handle, insert the extension tube
into the top of the vacuum
body.Gently turn the tube until it locks
in place.
^
To remove the extension tube, press
down on the locking button (see in
-
set) and pull.
Connecting the handle
^ Lining up the square hole and the
locking button, insert the handle into
the extension tube. Gently turn the
handle until it locks in place.
^ To remove the handle, press and hold
the locking button (see arrow) while
gently turning and pulling off the han-
dle.
The vacuum can be used as a hand
held vacuum by connecting the handle
directly to the vacuum housing.
This allows for easier vacuuming of up
-
holstered furniture, mattresses, etc.
In addition
(see next page)
Assembling the vacuum
12
To Next Page
Loading...
