Replacing the Active HEPA
filter
Do not use more than one exhaust
filter at a time.
^
Open the dust compartment lid.
^
Raise the Active HEPA filter and
remove it.
^
Replace with a new filter, and push it
down into place.
If you wish to replace the Active
HEPA filter with an Air Clean filter,
see "Replacing one type of exhaust
filter with another".
^ Close the dust compartment lid
firmly. It should click into place.
Resetting the exhaust filter change
indicator
The filter change indicator needs to be
reset each time the filter is replaced. To
do this, the vacuum cleaner must be
switched on.
^
Press the reset button.
The exhaust filter change indicator
goes out and resets to zero.
The filter change indicator can only
be reset by pressing the reset
button after the light has come on.
Pressing the button at any other time
will have no effect.
Maintenance and care
24
To Next Page
Loading...
