When to change the thread
lifters
The thread lifters on the suction inlet to
the floorhead and upholstery nozzle
can be replaced.
Check them from time to time and
replace them if the pile has worn down.
Correctly replacing the thread
lifters
^
Use a suitable tool to remove them
from the slots.
^
Fit new thread lifters.
Upholstery nozzle, 19 cm
^ Release the thread lifting unit on
either side of the upholstery nozzle
using a coin.
^ Replace the thread lifters.
If threads or hair have wound round
the bearing on the floorhead roller
a Release the bearing (with bayonet
fitting) using a coin.
b Press the bearing out, and remove.
c Remove the roller.
Remove any threads and hair, replace
the roller and refit the bearing.
Spare parts are available from your
Miele Vacuum Cleaner Specialist, from
Miele (see back cover for contact
details) or via the internet at
www.miele-shop.com.
Maintenance and care
26
To Next Page
Loading...
