Anti-crease
Once a programme has ended, the
drum will turn at regular intervals for
approx. 60 minutes to prevent the
laundry from settling into creases or
folds.
The Anti-crease function
–
is activated as standard ex-works. It
can be deactivated is wished.
–
takes place in: COTTONS, MINIMUM
IRON, Warm air programmes.
– should be left activated, if laundry is
not normally removed immediately
after the end of a programme.
Programming and storing in memory
The programmable functions are acti-
vated with the help of the additional op-
tion buttons and the programme selec-
tor.
Before you begin, first ensure that:
–
The tumble dryer is switched off.
–
The door is closed.
–
The programme selector is at
Finish
.
A Press the
Low temperature
and
Buzzer
buttons at the same time,
keep them pressed in
and ...
B ... switch the dryer on with the
I-On /
0-Off
button.
C Then release these buttons.
–
The
Drying
and
Cool air
sequence
indicator lamps will flash.
D Turn the programme selector to
COTTONS
Hand iron
r.
–
If the
Machine iron
indicator lamp
lights up, the anti-crease function is
activated.
–
If the
Machine iron
indicator lamp
does not light up, the anti-crease
function is deactivated.
E Pressing the START button switches
between activating and deactivating
the anti-crease function.
F Switch the machine off with the
I-On / 0-Off
button.
The setting you have selected is now
stored in memory. You can change it
again at any time.
To check:
^ Carry out steps A to D.
If the indicator lamp for Machine iron
lights up = Anti-crease is activated
does not light up = Anti-crease is de-
activated
^
Switch off the dryer with the
I-On /
0-Off
button.
The check is complete.
Programmable functions
48
To Next Page
Loading...
