Before you begin, ensure that:
–
The tumble dryer is switched off.
–
The door is closed.
–
The programme selector is at Finish.
A Press the Start button and keep it
pressed in whilst carrying out steps
B-C.
B Switch the dryer on.
C Wait until the Start indicator lamp
lights up constantly...
D . . . and then release the Start button.
E Turn the programme selector to
Woollens hand care.
The Cool air lamp will flash eight times.
The flashing sequence of the
Drying lamp shows which option is
currently selected.
–
If the Drying lamp is not flashing:
the Factory default setting has
been selected.
–
If the Drying lamp flashes once: Not
in current programme has been
selected.
– If the Drying lamp flashes twice:
Off has been selected.
F Pressing the Start button switches
between the 3 options.
G Switch the dryer off.
The setting you have selected is now
stored in memory. You can change it
again at any time.
To check the setting:
^
Carry out steps A to E.
^
Switch the dryer off after checking
the setting as described above.
Programmable functions
47
To Next Page
Loading...
