Standby
To save energy, the programme
sequence/check lamps go out and
the indicator lamp for the Start button
starts flashing slowly.
To come out of standby mode
^
Turn the programme selector or
press the Start button. Neither will
have any effect if a programme is
running.
Factory default
The standby function is activated and
the programme sequence/check lamps
will go out after 10 minutes:
– if a programme is not selected after
the dryer has been switched on.
– after a programme has started.
They will, however, come on for 10
minutes at the end of the programme or
the end of the anti-crease phase. The
buzzer (if selected ) will sound for 10
minutes at the end of the programme.
Instead of the factory default setting
you can select another option:
Not in current programme
As described under "Factory default"
above.
However, they will stay on after the
programme has started and remain
visible during the programme.
Off
The programme sequence/check
lamps will stay on while the dryer is
switched on.
Follow the steps (A,B,C ...) to
programme and store in memory.
^ See next page.
Programmable functions
46
To Next Page
Loading...
