To change a programme
Programmes cannot be changed after
the start button has been pressed. If
the programme selector is turned to a
different programme after a programme
has begun, this will not affect the
programme. The
Anti-crease / Finish
indicator lamp will flash. The indicator
lamp will go out when the selector is
returned to its original position.
After a programme has started, not all
additional options can be switched on
or off (see section "How to dry
correctly").
To interrupt a programme
^ Switch the machine off with the
I-On / 0-Off
button.
To continue drying:
^ Switch the dryer on with the
I-On / 0-Off
button.
The programme will continue, as long
as the cooling down phase has not
been reached.
To cancel a programme and select a
different programme
^
Turn the programme selector to
Finish
.
The programme has been
successfully cancelled when only the
Anti-crease/Finish
indicator lamp is
on.
^
Turn the programme selector to the
required programme.
^
Switch additional options on or off as
required.
^
Press the
Start
button.
Adding or removing items
^
Press the
Door
button and open the
door.
,
Do not touch the back of the
drum when adding or removing
items. The drum could be very hot -
danger of burning.
^
Items can now be added or removed
early.
To continue drying:
^ Close the door.
^ Switch additional options on or off as
required.
^ Press the
Start
button.
– The programme will continue.
– The time left shown in the display
may now vary from the actual drying
time.
How to dry correctly
19
To Next Page
Loading...
