Activating and
storing in the memory
The programmable functions are acti-
vated using the additional option but-
tons in special combinations with the
programme selector to introduce extra
features not marked up on the control
panel.
1 Switch the machine off and shut the
door.
Turn the programme selector to “Fin-
ish”.
2 Press the “Short” and “Low tempera-
ture” buttons in. Hold them there
and ...
3 ... switch the machine on by pressing
the “I-On / 0-Off” button.
4 Release all the buttons.
5 The “Drying” and “Cool air” indicator
lights will flash.
6 Turn the programme selector to one
of the following positions:
– COTTONS / Extra dry for the func-
tion
“Correcting the drying level”
– COTTONS / Normal + for the function
“Buzzer”
– COTTONS / Normal for the
"Memory function"
– COTTONS / Hand iron r
for the function
“Anti-crease”
7 If the “Machine iron” indicator light
comes on, then the chosen function
has been activated.
8 Each programmable function can be
switched on or off by pressing the
“START” button:
“Machine iron” indicator light
- on = Programmable function
activated
- off = Programmable function
de-activated.
9 If you wish to activate a further pro-
grammable function, repeat steps
6
to 8. If not:
0 To store in the memory:Turn the pro-
gramme selector to “Finish” and
switch the machine off by pressing
the “I-On/0-Off” button.
To de-select a programmable func-
tion
Carry out steps 1 to 0.
To check whether a programmable
function is activated:
Carry out steps 1 to 7.
Switch the machine off.
This completes the check.
Programmable functions
19
To Next Page
Loading...
