Installation
Washer-Dryer stack
This tumble dryer can be stacked on a
Miele washing machine. A stacking
kit* can be purchased from the Miele
Domestic Sales Department.
All parts marked * are available from
the Miele Spare Parts or Sales Depart-
ment.
Fitting or changing the decor panel
Note: The door should be shut for fit-
ting or changing the decor panel.
Remove the 4 screws from the decor
strip on the door catch side of the
door and remove the decor strip.
Unscrew the remaining 7 screws
from the lower and side decor strip
until the decor panel bows slightly
and can then be taken out or put in
place.
Re-assemble in the reverse order and
tighten the screws.
Decor panel dimensions
(The figures given in brackets indicate
the tolerance level in mm.)
Width: 587 (-1) mm
Height: 602 (-1.5) mm
Thickness: 1 (+ 0.5) mm
Panels more than 1.5 mm thick require
an "adapter strip for a 4 mm thick
decor panel". This is available from
your Miele Dealer or the Miele Spare
Parts Department.
Note:
The decor panel height required for
the adapter strip must not exceed
596.5 (-1.5) mm.
25
To Next Page
Loading...
Need help?
General
