Miele T 659 C - Activating and Storing in the Memory

Activating and storing in the
memory
The programmable functions are acti-
vated using the additional option but-
tons in special combinations with the
programme selector to intoduce ex-
tra features not marked up on the
control panel.
1 Switch the machine off and shut the
door.
Turn the programme selector to the
“Finish” position.
2 Press the “Low temperature” and
“Buzzer” buttons at the same time.
Keep them pressed in and ...
3 ... switch the machine on by pressing
the “I-On/0-Off” button.
4 Release all the buttons.
5 The indicator lights “Drying” and
“Cool air” will flash.
6 Turn the programme selector to one
of the following positions:
– COTTONS, extra dry
for programmable function
“Correcting the drying level”
– COTTONS, normal
for programmable function
“Memory”
7 If the “Machine iron” indicator light
comes on, then the chosen function
has been activated.
8 Each programmable function can be
switched on or off by pressing the
“START” button:
“Machine iron” indicator light
- on = Programmable function activa-
ted
- off = Programmable function
de-activated.
9 If you wish to activate a further pro-
grammable function, repeat steps
6
to 8. If not:
0 To store in the memory: Turn the pro-
gramme selector to “Finish” and
switch the machine off by pressing
the “I-On/0-Off” button.
To de-select a programmable functi-
on
Carry out steps 1 to 0 .
To check whether a programmable
function is activated:
Carry out steps 1 to 7.
Switch the machine off.
This completes the check.
Programmable functions
21