Activating and deactivating the
buzzer
A buzzer sounds (at intervals for a
maximum of 1 hour) to let you know
the programme has finished.
The tumble dryer is delivered with the
buzzer activated but you can
deactivate it if wished.
If there is a fault, a continuous tone will
sound even if the buzzer has been
deactivated.
Follow the steps (A,B,C ...) to
programme and store in memory.
Before you begin, ensure that:
– The tumble dryer is switched off.
– The door is closed.
– The programme selector is at Finish.
A Press the Start button and keep it
pressed in whilst carrying out steps
B-C.
B Switch the dryer on.
C Wait until the Start indicator lamp
lights up constantly...
D . . . and then release the Start button.
E Turn the programme selector to
Cottons Low temperature.
The Cool air lamp will flash four times.
The flashing sequence of the
Drying lamp shows which option is
currently selected.
–
If the Drying lamp is not flashing:
the buzzer is deactivated
–
If the Drying lamp is flashing:
the buzzer is activated (factory
default setting).
F Pressing the Start button switches
between the 2 options.
G Switch the dryer off.
The setting you have selected is now
stored in memory. You can change it
again at any time.
To check the setting:
^ Carry out steps A to E.
^
Switch the dryer off after checking
the setting as described above.
Programmable functions
46
To Next Page
Loading...
