With the help of the following notes, minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be put right
without contacting the Service Department.
,
Repair work to electrical appliances should only be carried out by a
suitably qualified person in strict accordance with current local and national
safety regulations. Repairs and other work by unqualified persons could be
dangerous. The manufacturer cannot be held liable for unauthorised work.
Check and fault messages in the display
Problem Possible cause Remedy
You are asked to enter a
code.
Access via a code has
been activated.
Enter the code (see
"Settings menu").
Adjust the load
The programme is
cancelled, the buzzer
sounds.
This is not a fault.
In some programmes, if
the drum has been
overloaded or
underloaded, the
programme will be
cancelled. This can also
happen if the items are
already dry.
Use the Warm air
programme (timed
drying) to dry individual
items.
– Switch the dryer off
and then on again.
– Open and shut the
door.
Empty the container
The programme is
cancelled, the buzzer
sounds.
The condensed water
container is full or there is
a kink in the drain hose.
–
Empty out the
condensed water
container or check the
drain hose.
–
Switch the dryer off
and then on again.
Problem solving guide
35
To Next Page
Loading...
Need help?
General