Miele T 8903 C User Manual

Check and fault messages
Problem Possible cause Remedy
The Empty out
container
indicator light
comes on.
The condensed water
container is full or there is a
kink in the drain hose.
–
Empty out the condensed
water container.
–
Check the drain hose.
–
The indicator light will go
out when the door is
opened and closed again.
The
Finish/Anti-crease
indicator light
flashes while
drying.
The programme selector
was turned after the start of
the programme. However,
the programme finishes
without problems.
Set the originally selected
programme: The indicator
light will go out.
Cancel the
programme. Cool
air flashes. The
buzzer sounds.
The dryer is not working
efficiently or economically.
See previous page: The
drying process goes on too
long (...).
Cancel the
programme.
The
Finish/Anti-crease
indicator light
comes on.
The buzzer
sounds.
This is not a fault.
The electronic unit
recognised that there was
no laundry in the drum and
cancelled the programme.
Drying individual garments
or items which are already
dry can also cause the
programme to be cancelled.
Use the Warm air
programme (timed drying) to
dry individual items.
– Open and close the door.
Cancel the
programme.
Cool air or
Finish/Anti-crease
flashes.
The buzzer
sounds.
There is no immediate
cause.
–
Switch the dryer off and
then on again.
–
Start a programme.
If the programme stops
again and Cooling down or
Finish flashes again, there is
a fault. Contact Miele.
Problem solving guide
26

Miele T 8903 C Specifications

General

Brand	Miele
Model	T 8903 C
Category	Dryer
Language	English