Switching the buzzer on/off
A buzzer sounds (at intervals for a
maximum of 1 hr) to let you know the
programme has finished.
The buzzer is activated as standard at
the factory. You can deactivate the
buzzer at the end of a programme if
you wish.
The buzzer will still sound if there is a
fault, even if it has been switched off.
Follow steps (A,B,C ...) with the
help of the Start button and
programme selector to programme
and store in memory.
Before you begin, first ensure that:
– The dryer is switched off.
– The door is closed.
– The programme selector is turned to
Finish.
A Press the Start/Stop button and keep
it pressed in whilst carrying out steps
B-C.
B Switch the dryer on.
C Wait until Start lights up
constantly. . .
D . . . and then release the Start button.
E Turn the programme selector to
Cottons Low temperature.
The Finish/Anti-crease indicator light
will flash four times.
The flashing Drying indicator light
shows which option is selected.
–
The Drying indicator light doesn't
flash:
Buzzer is switched off.
–
The Drying indicator light flashes:
Factory default setting. Buzzer is
switched on.
F You can switch from one option to
the other by pressing the Start button
(Drying indicator light).
G Switch the dryer off.
The setting you have selected is now
stored in memory. You can alter the
settings again at any time.
Control
^ Repeat steps A to E.
^
After checking the indicator lights
(see above), switch the dryer off.
Programmable functions
43
To Next Page
Loading...
Need help?
General
