Before you begin, first ensure that:
–
The dryer is switched off.
–
The door is closed.
–
The programme selector is turned to
Finish.
A Press the Start/Stop button and keep
it pressed in whilst carrying out steps
B-C.
B Switch the dryer on.
C Wait until Start lights up
constantly. . .
D . . . and then release the Start button.
E Turn the programme selector to
Woollens handcare.
The Finish/Anti-crease indicator light
will flash eight times.
The flashing Drying indicator light
shows which option is selected.
–
If the Drying indicator light doesn't
flash:
On.
– If the Drying indicator light flashes
once:
Factory default setting. Not in
current programme.
– If the Drying indicator light flashes
twice:
Off.
F You can switch from one option to
the other by pressing the Start button
(Drying indicator light).
G Switch the dryer off.
The setting you have selected is now
stored in memory. You can alter the
settings again at any time.
Control
^
Repeat steps A to E.
^
After checking the indicator lights
(see above), switch the dryer off.
Programmable functions
47
To Next Page
Loading...
