EasyManua.ls Logo

Miele TCE530 WP Active Plus - Page 49

Miele TCE530 WP Active Plus
76 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Problem solving guide
49
Problem Cause and remedy
and  light up after
a programme has been
cancelled, a signal
sounds
An excessive amount of fluff has built up.
Clean the fluff filters.
Clean the plinth filter.
Clean the airways: the area underneath the plinth
filter and the heat exchanger.
See "Cleaning and care".
To switch   off:
Switch the dryer off and then on again.
You can influence this error message yourself: see
"Programmable functions" and the part on the "
Airways indicator".
and another number
combination flash after
a programme has been
cancelled, a signal
sounds
No obvious cause.
Switch the dryer off and then on again.
Start a programme.
If the programme is cancelled again and an error
message appears, there is a fault. Contact the Miele
Service Department.
: lights up and the
programme has been
cancelled, a signal
sounds
The laundry is unevenly distributed or has rolled up.
Disentangle the laundry and remove a few items, if
necessary.
Switch the dryer off and then on again.
Start a programme.

Table of Contents

Related product manuals