What to do if...
44
With the help of the following notes minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be put right
without contacting the Service Department.
Repair work to electrical appliances must only be carried out by a suitably
qualified person in strict accordance with current local and national safety
regulations. Repairs and other work by unqualified persons could be
dangerous. The manufacturer cannot be held liable for unauthorised work.
Check indicators and fault messages
Problem Cause and remedy
The programme is
cancelled, lights up
This is not a fault.
In some programmes, if the drum has been
underloaded or is empty, the programme will be
cancelled. This can also happen if the items are
already dry.
Open and close the door to resume drying.
Dry individual items using the Warm air timed
drying programme.
flashes/lights up
after the tumble dryer
has been switched on
and a programme
cannot be selected
Access via a code has been activated.
See "Programmable functions - Code".
and (e.g. )
light up after a
programme has been
cancelled
No obvious cause.
Switch the dryer off and then on again.
Start a programme.
If the programme is cancelled again and an error
message appears, there is a fault. Contact the Miele
Service Department.
To Next Page
Loading...
Need help?
General
