Programmable functions
75
Standby
To save energy the display and
butt
ons will go out after 10 minutes
and only the
Start/Stop butt
on will
flash slowly. You can alter this setting.
However, standby mode will not occur
in the event of a fault.
Options
Standby switched on:
The display and buttons will go
out aft
er 10 minutes . .
. . . if no selection is made after
switching the dryer on.
. . . after a programme has
started.
However, the display and buttons
will remain lit up for 10 minutes
after a delay start time has
elapsed, after the end of the
programme or at the end of the
anti-crease phase. The buzzer, if
selected, will sound for 10
minutes after the end of the
programme.
Not in current programme
(fact
ory default setting)
As described under .
However
, the display and buttons
will remain lit up during the
programme.
Off
The display and buttons will
r
emain lit up while the dryer is
switched on.
To switch the display and buttons back
on again
– Turn the programme selector or press
a butt
on. Neither will have any effect
if a programme is running.
– Open the door while the dryer is
switched on.
To Next Page
Loading...
Need help?
General
