Problem solving guide
62
Replacing the plinth filter
The heat exchanger can clog up.
Replace the plinth filter immediately
if you see the following signs of wear
before or after cleaning (optional
accessory).
Poor fit
The edges of the plinth filter do not sit
properly and the plinth filter is out of
shape. Fluff will blow into the heat
exchanger unfiltered through edges that
do not sit properly. This will, in time,
cause a blockage in the heat
exchanger.
Deformations
Deformations indicate that the filter has
become blocked and worn by
continuous use.
To Next Page
Loading...
