Installation
*INSTALLATION*
91
Refitting
7. Refit the door
Press the rubber seal back into the
grove on the door.
Position the door in front of the dryer.
Fit the base of the door hinge with its
2 pins into the openings on the dryer.
The base of the door hinge must be
flush with the front panel of the dryer.
The door cannot fall off in this position.
Screw the door securely to the dryer
at the base of door hinge .
Now that you have changed the
door hinging the door will open from
the opposite side.
Push the orange marker round to the
other side so that you will see at
which side to pull the door open.
Important
Please keep the lock catch and
door hinge covers which were no
longer needed in a safe place. These
will be required if, for example, you
move house and need to change the
door hinging back to its original posi-
tion.
To Next Page
Loading...
Need help?
General
