Miele W 844 - Programme interruption

Programme . . .
. . . interruption
Press the “I-ON/0-OFF” button.
To continue with the same pro-
gramme press the“I-ON/0-OFF” but-
ton again.
. . . alteration
The machine will accept the following
changes after the "Start" button has
been pressed,
– selection of a different temperature,
extra selection or de-selection of the
“Water plus” option can be carried
out up to 6 minutes after start.
– the spin speed for final spin can be
changed if the programme permits.
After start it is no longer possible to se-
lect a different programme.
If a different programme or 6 minutes
after start another temperature is se-
lected the indicator light "Anti-
crease/Finish" flashes. This does not af-
fect the programme sequence. The
indicator light goes out when the pro-
gramme selector is set back to the pro-
gramme or temperature previously
chosen.
To select a different programme pro-
ceed as follows:
With the “I-On/0-Off” button switch
off the appliance.
Turn the programme selector to
"Finish".
Switch the machine on with the
“I-On/0-Off” button.
Select a new programme.
Press the “START” button.
. . . Skipping a programme stage
Turn the programme selector to
“Finish”.
As soon as the programme sequence
light for the stage at which the pro-
gramme should continue starts flashing:
Turn the programme selector switch
to the appropriate programme within
4 seconds.
When programme locking has been
activated the programme cannot be
changed nor can a programme
stage be repeated or left out.
How to wash correctly
18