Miele W 939 WPS - Programming and Storing Functions

Programming and storing in
memory
The programmable functions are acti
-
vated to call up further features not
shown on the control panel by using the
additional option touch pads in combi
-
nation with the programme touch pads.
Programming is carried out in for steps:
1. Select programming mode
2. Select programmable function
3. Activate or deactivate the program
-
mable function
4. Save the programmable function in
memory
1. Selecting programming mode
A The machine must be switched off
and the drum door closed.
B Press the
Cottons and the Soak
touch pads at the same time, hold
pressed in and
C . . . switch the machine on with the
I-ON/0-OFF button.
D Let go of all these touch pads/but
-
tons.
P 0 will appear in the display.
2. Selecting a programmable function
E Press the & touch pad under the
display. The P will now flash in the
display alternating
with the number
of the programmable function e.g.
P...1...P...1
F Press the $& touch pads repeat
-
edly until the the display shows the
number of the programmable func
-
tion required, alternating with the P.
P1 = High water level
P2 = Water plus system
P4 = Activate compartment i
P9 = Gentle action
P10 = Activate top-up rinse for
Cottons
P11 = Memory function
In addition, one of the following will ap-
pear on the right of the display:
P0= Programmable function is
de-activated
P1= Programmable function is
activated
with P 2 a 2 will appear on the right to
show that option 2 is active.
Programmable functions
35