To check if the function has
been stored:
Carry out Steps1to4.
If the “Rinse 1-2” lamp lights up, the
programmable function is activated.
Press the “ON/OFF” button. This fi-
nishes the check of the program-
mable function.
If, after Step 2, the selector switch is
accidentally turned to a setting
other than one of the three shown:
– If the “Rinse 1-2” indicator does
not light up - no function was acti-
vated
– If the “Rinse 1-2” indicator lights
up - proceed as in “Deleting the
additional functions”.
Exception: the “Rinse 1-2” indicator
will light up if the switch is set to
“COTTONS 95°C”.
Deleting the additional func-
tions:
Follow the same instructions given
under “To activate the additional func-
tions”, steps 1 to 4.
When the “Rinse 1-2” lamp goes out;
Press “ON/OFF”.
The additional function has now been
deleted.
Programmable functions
26
To Next Page
Loading...
