Miele W5748 - Fault Messages and Programme Stops

The following fault messages appear in the display and the
programme stops
Fault message Possible cause Remedy A
;
Drain
fault
–
The water outlet is
blocked or restricted.
–
The drain hose has
been fixed too high.
–
Clean the drain filter and
the drain pump.
–
The maximum delivery head
is1m.
;
Water inlet
fault
The water inlet is blocked
or restricted.
Check whether
–
the stopcock is opened
properly.
–
the inlet hose is kinked.
– the water pressure is too
low.
The filter in the water inlet
hose is dirty.
Clean the filter.
;
Waterproof
fault
The water protection
system has reacted.
– Close the stopcock.
– Call the Service
Department.
;
Technical
fault
There is a fault. Start the programme again.
If the fault message appears
again, contact the Service
Department.
A To switch off the fault message: Switch the machine off with the K button.
Problem solving guide
40