,
To avoid the risk of injury the
holes for the transit bars must be
covered after the transit bars have
been removed.
^ Fit the covers on to the two holes.
Then plug the holes as shown with
the caps.
,
The machine must not be moved
without the transit bars in place.
Store them in a safe place for future
use. They must be re-fitted if the
machine is to be moved again (e.g.
when moving house).
Re-fitting the transit bars
Re-fitting is carried out by reversing the
procedure.
Levelling the machine
The machine must stand perfectly level
on all four feet to ensure safe and
proper operation.
Incorrect installation may increase
electricity and water consumption and
may cause the washer-dryer to move
about. False values may also show in
the Load and Detergent display.
Installation and connection
70
To Next Page
Loading...
Need help?
General
