Miele WCG660 WCS User Manual

Before using for the first time
22
Settings for compartment
The UltraPhase2 values are preset in
the standard settings.
After the cartridge has been pushed in,
the display message switches to:
Agent for 
OK





 Confirm with the OKsensor control.
Miele UltraPhase 2
OK




 Confirm with the OKsensor control.
The dispensing quantity for
UltraPhase2 is preset for (hardness
level II).
Per load
OK




ml45
 Confirm the preset value with the
OKsensor control. If you want to
change this value, use the
sensor controls and confirm with
the OK sensor control.
UltraPhase2
 Hardness level I 36ml
 Hardness level II 45ml
 Hardness level III 54ml
The following will appear in the display:
 Insert 
 Remove the film from the detergent
cartridge.
 Push the UltraPhase2 detergent
cartridge into compartment2 until it
locks into position.
When the cartridge is pushed in, the
display message switches to:
 “TwinDos” is set. Can be changed in “Set-
tings”.
 Confirm with the OK sensor.
 Close the TwinDos access panel.

Miele WCG660 WCS Specifications

General

Brand	Miele
Model	WCG660 WCS
Category	Washer
Language	English