Miele WS 5101 - Operation: Program Adjustments; Changing Temperature and Spin Speed; Detergent and Additive Usage

Changing temperaure and spin
speed
The following parameters can be changed
before the start of a program:
–
the temperature in 1 °C steps from cold,
15 °C to maximum 95 °C .
–
the spin speed in 100 rpm steps.
WS 5101 300 - 1500 rpm
WS 5141 300 - 1000 rpm
PROGRAMME 1 COTTONS
>60 °C< Prewash 1
95 °C Main wash 1
Rinses 3 1000 RPM
^
Use the 2 "Cursor" to position the cursor
on the input field for the Prewash tempera
-
ture, and set the temperature required
(here 60 °C) with the 3 4 "Minus or Plus".
^ Position the cursor on the input field for the
Main wash temperature, and set the tem-
perature required with 3 4 "Minus or
Plus".
^ Position the cursor on the input field for the
spin speed, and set the spin speed requi-
red with the 3 4 "Minus or Plus".
Adding detergent
^
For the standard programs add detergent
for the main wash into compartment II and,
if required into compartment I for the
prewash. Fabric softener is put into com
-
partment § and liquid bleach is put into
the compartment without a symbol.
Detergent use
^
Only use low sudsing detergents. Do not
oversuds the unit with too much detergent.
^
Take into account the water hardness, and
the detergent manufacturer’s instructions
when filling the dispenser.
^ Do not fill fabric softener or bleaching
agent higher than the level marker in the
relevant dispenser compartment.
Otherwise they will be siphoned into the
suds container.
^ Press X "Start" to begin washing.
Operation
14